TROUBLESHOOTING PRECAUTIONS WHEN CARRYING OUT MAINTENANCE 3. POINTS TO REMEMBER WHEN HANDLING HYDRAULIC EQUIPMENT With the increase in pressure and precision of hydraulic equipment, the most common cause of failure is dirt (foreign material) in the hydraulic circuit. When adding hydraulic oil, or when disassembling or assembling hydraulic equipment, it is necessary to be particularly careful. 1) Be careful of the operating environment. Avoid adding hydraulic oil, replacing filters, or repairing the machine in rain or high winds, or places where there is a lot of dust.
2) Disassembly and maintenance work in the field If disassembly or maintenance work is carried out on hydraulic equipment in the field, there is danger of dust entering the equipment. It is also difficult to confirm the performance after repairs, so it is desirable to use unit exchange. Disassembly and maintenance of hydraulic equipment should be carried out in a specially prepared dust proof workshop, and the performance should be confirmed with special test equipment. 3) Seal or cover all openings of disconnected piping After any piping or equipment is removed, the openings should be sealed with caps, tape, or vinyl bags to prevent any dirt or dust from entering.
Never leave any openings opened or blocked with a rag, this could cause particles or dirt to get into the system. Drain all oil into a container and not unto the ground and be sure to follow the proper environmental regulation for any disposal of oil. 4) Do not let any dirt, or dust get in during refilling operations. Be careful not to let any dirt or dust get in when refilling with hydraulic oil. Always keep the oil filler and the area around it clean, and also use clean pumps and oil containers. If an oil cleaning device is used, it is possible to filter out the dirt that has collected during storage, so this is an even more effective method. 20-111 WA250-3L