TROUBLESHOOTING METHOD OF USING TROUBLESHOOTING CHARTS 3) Operate the machine and check the troubleshooting items other than those in 1). Operate the machine and check the items in the same way as in 1) and if the symptom appears, mark that item. (In the chart on the right, the symptom appears again for item 5). 4) Find the appropriate cause from the cause column. In the same way as in Step 2), if the symptom appears, the F marks on that line indicate the possible causes. (For item No.5 in the table on the right, the possible causes are b or e .) 5) Narrow down the possible causes. There is one common cause among the causes located in Steps 2) and 4).
(One cause marked F , appears on the line for both items.) This cause is common to both the symptoms in troubleshooting Steps 1) and 3). i The causes which are not common to both troubleshooting items (items which are not marked F for both symptoms) are unlikely causes, so ignore them. (In the example given on the right, the causes for Troubleshooting Item 2 are c or e, and the causes for Troubleshooting Item 5 are b or e, so cause e is common to both.) 6) Repeat the operations in Steps 3), 4) and 5) until one cause (one common cause) remains. i If the causes cannot be narrowed down to one cause, narrow the causes down as far as possible.
7) Remedy If the causes are narrowed down to one common cause, take the action given in the remedy column. The symbols given in the remedy column indicate the following: X : Replace, : Repair, A ; Adjust, C : Clean 20-125 WA250-3L