TROUBLESHOOTING E-5 E-5 Transmission does not work normally i Stop the machine on level ground when carrying out troubleshooting of the brake system. i To prevent failures, always turn the starting switch OFF when connecting or disconnecting connectors in order to connect the T-adapter (or socket adapter) or short circuit connector when carrying out checks. i When connecting the T-adapter (or socket adapter), connect to the connector specified in CNO ) ( ). i After checking, disconnect the T-adapter and connect the disconnected connectors immediately before going on to the next step unless otherwise specified. Carry out check of transmission solenoid control circuit WARNING!
Stop the machine on level ground and put blocks under the wheels. 1. Install a T-adapter checker to connector CNFT1, and check the voltage between the connector pins and the chassis ground. 2. Turn the starting switch ON. WARNING! Do not start the engine under any circumstances. 3. Turn the parking brake switch ON OFF (release). 4. When using the foot brake, depress the right brake so that the transmission cut-off is not turned off. 5. Check according to the normal actuation table below, and if there is any abnormality, use the result below and go to the Troubleshooting given in the column on the right. 20-191 WA250-3L