TROUBLESHOOTING E-10 E-10 Preheating is not carried out i To prevent failures, always turn the starting switch OFF when connecting or disconnecting connectors in order to connect the T-adapter (or socket adapter) or short circuit connector when carrying out checks. i When connecting the T-adapter (or socket adapter), connect to the connector specified in CNO ) ( ). i After checking, disconnect the T-adapter and connect the disconnected connectors immediately before going on to the next step unless otherwise specified. i Check that the water temperature is 0 E C or below. i Refer to electrical wiring diagram in section 20 TROUBLE SHOOTING ELECTRICAL CIRCUIT DIAGRAM FOR EACH SYSTEM.
PREHEATING SYSTEM” 20-215 WA250-3L