DISASSEMBLY AND ASSEMBLY RADIATOR RADIATOR Warning! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. Warning! Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the control levers several times to release the remaining pressure in the hydraulic piping. Warning! Disconnect the cable from the negative (-) terminal of the battery. REMOVAL 1. Engine hood and side covers Refer to “REMOVAL OF ENGINE HOOD”. 2.
Draining coolant Loosen radiator cap (1) to release internal pressure, and open drain valve (2) and drain coolant from system. Ъ When system is drained close the drain valve. Ъ If the coolant contains antifreeze, dispose of it properly. Coolant: 36.5 R (9.6 US gals) 3. Fan guards Remove fan guard (3). Ъ Be careful not to damage radiator fins. Ъ Remove the left and right fan guard with them still connected 4. Rear cover Remove cover (4) at the bottom rear of the radiator. 5. Radiator hoses Disconnect radiator hoses (5) (6) and (7) at engine end. 30-20 WA250-3L