DISASSEMBLY AND ASSEMBLY ENGINE INSTALLATION ! Carry out installation in reverse order of removal i Install radiator and hood. For details, see “INSTALLATION OF RADIATOR”. Mounting bolt: 745 ± 83 Nm (76 ± 8.5 kgm) (Width across flats: 32 mm) i Check that there is a O-ring installed to the mating face of the torque converter. Outside circumference of O-ring: Soapy water i When connecting the engine and torque converter, adjust the height so that the torque converter pilot goes in smoothly. Never use force when connecting. i When assembling the rubber, never use grease, oil, or soapy water. ! Refilling with oil and water.
1) Tighten drain valve and add water through water filler to the specified level. 2) Add transmission oil through oil filler to the specified level. i Run the engine to circulate the oil through the system. Then check the oil level again. 30-26 WA250-3L