DISASSEMBLY AND ASSEMBLY ACCUMLATOR VALVE 7. Remove plugs (19) and (20) from cover (10). Ъ Plug: 5 mm (Width across flats) Ъ Do not remove the plug unless necessary. Ъ If plugs (19) and (20) have been removed, coat the thread with thread tightener as shown in the diagram, then tighten the plugs. Ъ Be careful not to get thread tightener on the hatched area when coating with thread tightener. Plug: Thread tightener (LG-1) ASSEMBLY 1. Set pads in vice, then set accumulator valve cover (10) in vice. Ъ Be careful not to tighten the cover with any excessive force. 2.
Insert spacers (18), (17), and (16), stoppers (15) and (13), and springs (14) and (12) in accumulator valve cover (10), then insert valves (11) from above each spring. 3. Insert O-rings (21) and (22) in each groove of accumulator valve body (9). Ъ Assemble O-rings in the groove of the body securely. 4. Place accumulator valve body (9) perpendicular to cover (10), and temporarily assemble with guide bolts. Ъ Assemble the body slowly and be careful not to let the O- ring fall out. 5. Push in accumulator valve body (9),then remove guide bolts and secure with specified bolt. Mounting bolt: 53.9 ± 19.6 Nm (5.5 ± 2.9 kgm) (Width across flats: 8 mm) 30-98 WA250-3L