DISASSEMBLY AND ASSEMBLY DRIVE SHAFT DRIVE SHAFT ASSEMBLY 1. Spider, bearing 1) Set spider (10) and bearing (6) in mounting position, assemble ring (7), then install. Ъ Assemble so that the grease nipples face in the same direction. Ъ Repeat thesame procedure for the front, center and rear drive shafts. 2) Install bearing cap (5). Ъ Check that the there is a bearing and Derling washer inside the bearing cap. Bearing cap: Grease (G2-L1) Ъ If the spider and bearing caps are worn, replace the spider and bearing. Ъ Heat will damage the bearing, so do not weld strap (8) of the cap. 2. Front drive shaft 1) Press fit flange bearing (4). Ъ Do not hit the flange bearing directly with a hammer.
2) Align match marks, install coupling (3) and retainer (9), then tighten mounting bolt (2). Ъ Tighten the bolts to the specified tightening torque after installing on the machine. Spline: Grease (G2-L1) Mounting bolt: 279.5 ± 29.4 Nm (28.5 -± 3.0 kgm) 30-101 WA250-3L