Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY REAR AXLE 2) Sling one side of axle (6) and set garage jack under axle housing on other side, then remove mounting bolts. Ъ Adjust the height of the garage jack when removing. Ъ The pivot end will go down, so be extremely careful when removing the axle. Rear axle, pivot: 573 kg 3) Pull out axle assembly from chassis. Ъ Use a hoist and jack for the operation. Ъ After pulling the axle assembly out from the chassis, remove the wire. Ъ The clearance from the engine oil drain tube is small, so be careful when removing. 7. Rear pivot 1) Remove trunnion cap (7) Ъ If there are shims installed, check the number and thickness of the shims and use for reference when assembling.

Ъ Remove the grease tube. 2) Remove thrust washer (8), thrust plate (9), and thrust washer (10) 30-108 WA250-3L