Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY BOOM CYLINDER BOOM CYLINDER REMOVAL WARNING! Stop the machine on level ground and install the safety bar on the frame. Lower the bucket to the ground and stop the engine. Then apply the parking brake and put blocks under the wheels to prevent the machine from moving. WARNING! Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Then operate the control levers several times to release the remaining pressure in the hydraulic piping. 1 . Rod pin 1) Sling boom cylinder (1), then remove lock bolt, and remove pin (2). Ъ After removing the boom, set stand в under the tip of the boom.

2) Start engine, and operate control [ever to retract cylinder rod (3) of cylinder which has been removed. Ъ When retracting the rod, do not operate it to the end of the stroke. Leave approx. 20 mm. 2. Hydraulic piping 1) Disconnect rod tube (4) from connecting portion of hose (5). 2) Disconnect bottom tube (6) from connecting portion of hose (7). Ъ After disconnecting, fit covers to prevent dirt, dust, or water from entering. 3. Boom cylinder 1) Remove lock bolt, then remove bottom pin (8). Ъ If there are shims, check the number and thickness of the shims, and keep in a safe place. 2) Lift off boom cylinder (1). Ъ Be careful of the center of gravity, and remove slowly.

Ъ Be careful not to damage the cylinder rod. Boom cylinder: 87 kg 30-184 WA250-3L