Komatsu — FINAL DRIVE

MAINTENANCE STANDARD FINAL DRIVE FINAL DRIVE Unit: mm 40-26 No.

Check item Criteria Remedy 1 Clearance between axle housing and ring gear Standard size Tolerance Standard clearance Clearance limit Replace Shaft Hole Front axle 316 +0.100 +0.030 +0.1 0 -0.100 - 0.070 - Rear axle 276 +0.100 +0.030 +0.100 +0.030 -0.100 - 0.070 - 2 Clearance of guide pin 12 +0.025 +0.007 +0.207 +0.145 +0.120 - +0.200 - 3 Clearance at press-fitting portion of axle housing bearing Inner race 125 0 -0.018 -0.028 -0.068 -0.068 - -0.010 - Outer race 80 +0.030 +0.011 0 -0.015 -0.045 - -0.011 - 4 Clearance at press-fitting portion of axle housing bearing Inner race 130 0 -0.025 -0.028 -0.068 -0.068 - -0.003 - Outer race 85 +0.045 +0.023 0 -0.020 -0.065 - -0.023 - 5 Axle shaft press-fitting portion Housing 140 - +0.063 0 - - Shaft 105 0 -0.054 - - -- 6 Clearance between pinion gear bearing and shaft 33.338 +0.025 +0.013 +0.013 0 -0.025 - 0 - 7 End play of axle shaft Max.

0.1 - 8 Free rotation torque of axle shaft Max. 12.3 Nm (1.25 kgm) (including rotating resistance of seal carrier) 9 Clearance between oil seal and housing 0.1 - 0.09