Demontage und Montage, Motor komplett Disassembly and reassembly of complete engine Dйmontage et montage moteur complet Despiece y ensamblado conjunto de motor English Franзais Espacol 15. Fit main bearing caps, paying attention to numbering. 15. Monter le chapeau de palier prin- cipal selon la numйrotation. 15. Montar las tapas de los cojinetes de apoyo, teniendo en cuenta su numeraciyn. 16. Tighten main bearing bolts. 16. Serrer les vis des paliers de ligne d’arbre. 16. Apretar los tornillos de los cojinetes de apoyo. Tightening specification: Initial tightening torque 20 - 30 Nm Tightening angle 60 ° + 45 ° Consigne de serrage:
Valeur de prйserrage 20 - 30 Nm Serrage а l’angle 60 ° + 45 ° Prescripciyn de apriete: Par de apriete inicial 20 - 30 Nm Angulos de reapriete 60 ° + 45 ° Injection pump Pompe d’injection Bomba de inyecciyn 17. Fit new O-ring. 17. Monter un joint torique neuf. 17. Montar un anillo tyrico nuevo. 18. Mount injection pump so that studs are positioned in the middle of flange holes. Tighten hex. nuts. 18. Monter la pompe d’injection en po- sition milieu par rapport aux trous de bride. Serrer les vis six pans. 18. Montar la bomba de inyecciyn con los espбrragos situados en el centro de los orificios existentes en la brida. Apretar las tuercas hexagonales. 4 Tightening specification:
44 ± 4 Nm Consigne de serrage: 44 ± 4 Nm Prescripciyn de apriete: 44 ± 4 Nm 4.00.17 © 2002 / 0297 9763