. OPERATION EXPLANATION OF COMPONENTS If the dump control lever is not at the FLOAT position or the dump body is still raised, and the gear shift lever is SECONDARY BRAKE PEDAL Use secondary brake pedal (7) to apply the front brake and parking brake to stop the machine. Use this brake when the brake suddenly does not work due to damage to the brake pedal. REMARK If the pressure of accumulated in the brake hydraulic circuit accumulator goes down, the secondary brake will be actuated automatically. To move the machine, it is necessary to cancel the secondary brake. For details of the method of canceling the secondary brake, see "WHEN PARKING BRAKE HAS BEEN ACTUATED IN EMERGENCY (PAGE 3-141)".
3 - 13 Position D : el. This is the position for normal trav If the dump body is still raised, the t ransmission is fixed in 1st speed and will not shift to an y other speed ran ge. When traveling, lower the dump body, se t the dump control lever to FLOAT, then press the l ock button on the lever and move the lever to position D. REMARK To comply with the EU safety stand ards (EN 474-6 5.1.3), if the machine travels with the dump body not c ompletely lowered, the transmission is fixed in 1st and the gear cannot be shifted. Positions 6 - L:
Select the desired position in place s where it is difficult to travel at high speed, when tra veling on soft gro und, when starting off up a slope when the m achine is loaded, or when using the engine as a bra ke when traveling downhill. When switching between FORWA RD and REVERSE, release the accelerator pedal, depress the brak e pedal to stop the machine completely, then run the engine at low idle and change the direction. Press the lock but ton on the gear shift lever and move the leve r from position N to position R or to any position from D to 6.
moved from position N to any othe r position, the central warning lamp lights up and th e alarm buzzer so Do not place the gear shift lever in position N when the machine is traveling. It will be imp ossible for the tra nsmission to control the travel speed. ACCELERATOR PEDAL djust the engine speed. Use this accelerator pedal (5) to a The engine speed can be adjusted freely between low idle and full throttle by the amount that the pedal is d epressed. BRAKE PEDAL he front brakes and rear brakes to adjust the travel speed of the machine.
Use this brake pedal (6) to apply t he front brakes and rear brakes to adjust the travel s peed of the mach The braking force of the front brak es and rear brakes can be adjusted by the amount t hat the pedal is d epressed.