daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Coolant Water DAEWOO recommends selecting automotive antifreeze suitable for gasoline engines using aluminum alloy parts. The antifreeze should meet ASTM-D3306 standard. Hard water, or water with high levels of calcium and magnesium ions, encourages the formation of insoluble chemical compounds by combining with cooling system additives such as silicates and phosphates. Make proper antifreeze additions. The tendency of silicates and phosphates to precipitate out-of-solution increases with increasing water hardness. Hard water, or water with high levels of calcium and magnesium ions encourages the formation of insoluble chemicals, especially after a number of heating and cooling cycles.

Adding pure antifreeze as a makeup solution for cooling system top-up is an unacceptable practice. It increases the concentration of antifreeze in the cooling system which increases the concentration of dissolved solids and undissolved chemical inhibitors in the cooling system. Add antifreeze mixed with water to the same freeze protection as your cooling system. DAEWOO prefers the use of distilled water or deionized water to reduce the potential and severity of chemical insolubility. ppm = parts per million Using water that meets the minimum acceptable water requirement may not prevent drop-out of these chemical compounds totally, but should minimize the rate to acceptable levels.

Antifreeze NOTICE DAEWOO recommends that the coolant mix contain 50% commercially available automotive antifreeze, or equivalent, and acceptable water to maintain an adequate water pump cavitation temperature for efficient water pump performance. Premix coolant solution to provide protection to the lowest expected outside (ambient) temperature. Pure undiluted antifreeze will freeze at -23 ° C (-10 ° F). Only use a greater concentration (above 50%) of commercially available automotive antifreeze an needed for anticipated outside (ambient) temperatures.

Do not exceed the recommendations, provided with the commercially available automotive antifreeze, regarding the coolant mixture of antifreeze to water. G424 Service Manual Cooling System 115 Acceptable Water Water Content Limits (ppm) Chlorides (Cl) 40 maximum Sulfates (SO ) 4 50 maximum Total Hardness 80mg/M maximum Total Solids 250 maximum pH 6.0~8.0