H Crankshaft sprocket removal MB990767 (1) Using the special tool show in the illustration, lock the camshaft sprocket in position. (2) Loosen the camshaft sprocket bolt. MD998719 6EN0668 Inspection 1. Timing Belt Replace belt if any of the following conditions exist. (1) Hardening of back rubber. Back side is glossy without resilience and leaves no indent when pressed with fingernail. 8EN0066 Cracks Cracks (2) Cracks on rubber back. (3) Cracks or peeling of canvas. (4) Cracks on tooth bottom. (5) Cracks on belt sides. Peeling Cracks Cracks 8EN0044 (6) Abnormal wear of belt sides. Rounded edge NOTE: The sides are normal if they are sharp as if cut by a knife.
Abuormal wear (Flutty strand) 8EN0067 G424 Service Manual Base Engine Service Procedure 123