(2) Place the lash adjuster in container A and clean its outside surface. NOTE: Use a nylon brush if deposits are hard to remove. Diesel fuel 6EN1699 (3) While gently pushing down the internal steel ball using special tool MD998442, move the plunger through five to ten strokes until it slides smoothly. In addition to eliminating stiffness in the plunger, this operation will remove dirty oil. Caution: The steel ball spring is extremely weak, so the lash adjuster’s functionality may be lost if the air bleed wire is pushed in hard. Diesel fuel MD998442 6EN1808 NOTE: If the plunger remains stiff or the mechanism appears otherwise abnormal, replace the lash adjuster.
(4) Remove the lash adjuster from the container. Then, push down the steel ball gently and push the plunger to eliminate diesel fuel from the pressure chamber. Diesel fuel MD998442 6EN1809 (5) Place the lash adjuster in container B. Then, gently push down the internal steel ball using special tool MD998442 and move the plunger through five to ten strokes until it slides smoothly. This operation will clean the lash adjuster’s pressure chamber. Caution: The steel ball spring is extremely weak, so the lash adjuster’s functionality may be lost if the air bleed wire is pushed in hard. Diesel fuel 6EN1808 G424 Service Manual Base Engine Service Procedure 135