daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

2. Valve (1) Check the valve face for correct contact. If incorrect, reface. Valve seat contact should be maintained uniform at the center of valve face. (2) If the margin exceeds the service limit, replace the valve: Standard value: Intake 1.2 mm (0.047 in.) Exhaust 2.0 mm (0.079 in.) Limit: Intake 0.7 mm (0.028 in.) Exhaust 1.5 mm (0.059 in.) (3) Measure the valve’s total length. If the measurement is less than specified, replace the valve. Valve seat contact Margin 6EN0542 Standard value: Intake 106.6 mm (4.197 in.) Exhaust 105.2 mm (4.142 in.) Limit: Intake 106.1 mm (4.177 in.) Exhaust 104.7 mm (4.122 in.) 3.

Valve Spring Out of squareness (1) Measure the free height of spring and, if it is smaller than the limit, replace. Standard value: 48.0 mm (1.89 in.) Limit: 47.0 mm (1.85 in.) Free height (2) Measure the squareness of the spring and, if the limit is exceeded, replace. Standard value: 2 degrees or less Limit: 4 degrees 1EN0264 4. Valve Guide Measure the clearance between the valve guide and valve stem. If the limit is exceeded, replace the valve guide or valve, or both. Valve guide Guide I.D. Stem I.D. 1EN0279 G424 Service Manual Base Engine Service Procedure 141