Removal Service Points MD998727 A Oil pan removal (1) Remove the all oil pan bolts. (2) Drive in the special tool between the cylinder block and oil pan (3) Side the tool by striking the edge of the special tool to separate the oil pan from the cylinder block. 6EN0698 B Plug removal MD998162 (1) Fit special tool MD998162 on the plug, then hold it in position with special tool MD998783. (2) Loose the plug. MD998783 6EN0909 C Oil pump oil seal installation (1) Remove the plug on the side of cylinder block. (2) Insert a phillips screwdriver(shank diameter 8mm[0.31 in.]) into the plug hole to lock the counterbalance shaft. Screw driver Plug 6EN1026 (3) Loosen the flange bolt.
6EN0565 G424 Service Manual Base Engine Service Procedure 146