H Front case installation (1) Set the special tool on the front end of the crankshaft and apply a thin coat of engine oil to the outer circumference of the special tool to install the front case. MD998285 6EN0746 (2) Install the front case assembly through a new front case gasket and temporarily tighten the flange bolts(other than those for tightening the filter bracket). MD998285 6EN0747 I Flange bolt installation (1) Insert a Phillips screwdriver into a hole in the left side of the cylinder block to lock the counterbalance shaft. Screw driver 6EN0564 (2) Secure the oil pump driven gear onto the left counterbalance shaft by tightening the flange bolt to specified torque.
6EN0565 G424 Service Manual Base Engine Service Procedure 151