Replace LP Fuel Filter Element Park the lift truck in an authorized refueling area with the forks lowered, parking beake applled and the transmission in NEUTRAL. 5 4 3 2 1 6 4. Remove cover (5), magnet (4), spring (3) and filter element (2) from bottom cover (1). 5. Replace the filter element (2). 6. Check bottom cover O-ring seal (6) for damage. Replace it if necessary. 1. Close the fuel shutoff valve on the LP-Gas tank. Run the engine until fuel in the line runs out and the engine stops. Turn off the ignition switch and disconnect switch (if equipped). 7. Install the filter element (2), spring (3), magnet (4) and cover (5) on bottom cover (1). Align the scribe line on the covers. 8.
Install the cover retaining screws. Tighten the screws in a sequence opposite each other. 9. Open the fuel valve by slowly turning the valve counterclockwise. 10. Crank the engine only enough to produce a vacuum at the fuelock. Turn the ignition key switch off. 11. Check the fuel lines and fittings for leaks with a soap solution. Make repairs if necessary. Test Fuel Lock (Electric) • Start engine. • Locate electrical connector for fuel lock. • Disconnect electrical connector. • Engine will run out of fuel and stop in a short period of time. (The length of time increases with any increase in distance between the fuel lock and the pressure regulator). 2.
Scribe a line across the filter housing covers. 3.Remove the cover retaining screws. G424 Service Manual Maintenance 19