daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Governor advance mechanism In the figure below, pin A rotates together with the shaft. A governor weight is installed to this pin A. There is a pin B on the governor weight which fits into the oblong hole in the cam base. The governor spring is attached to the spring hook of the governor weight, pulling the governor weight to the fully closed position. When the rotation speed increases, the governor weight is subjected to centrifugal force which causes it to open outward. When the centrifugal force becomes stronger than the tensile force of the spring, the weight opens, as shown by (b) in the figure below, thus maintaining a balance with the force of the spring.

Because pin B of the weight is fit into the oblong hole In the cam base, the movement of pin B becomes rotation of the cam in the direction of rotation. In other words, the cam advances in relation to the shaft. When the rotation speed becomes sufficiently high, pin B contacts the outer side of the oblong hole in the cam base, and the weight opens no further. This position is the fully advanced condition. When the rotation speed decreases, the centrifugal force of the weight becomes weaker and the weight is closed by the force of the spring, thus returning to the original condition.

The advance characteristic of the centrifugal-advance device employed by the governor is as shown in the figure at the left. Point A is the beginning of advance, and point B shows the rotation speed at full advance. G424 Service Manual Ignition System 52