Power Mixture Adjustment CO Meter Method The method of adjustment depends upon the test equipment that is available. The power mixture can be adjusted using a CO meter, vacuum gauge or electri- cal system analyzer. The CO meter method is the pre- ferred method for reduced emissions. The vacuum gauge method is the next most accurate method if CO measuring equipment is not available. The engine speed method is the easiest but least accurate method. The power mixture adjustment must be done with the engine in a load condition. A CO meter or exhaust ana- lyzer testing equipment must be used to measure the CO content in the exhaust fumes.
To adjust the power mixture, turn knob either toward the "L" (lean) or "R" (rich) fuel flow mixture for a 1.0 to 1.5 percent CO indi- cation on the test equipment. Start the adjustment with knob in the middle position. NOTE: A lift truck, that does not operate with a heavy load all the time, can operate efficiently with a leaner power mixture setting (less than 1.0 to 1.5 percent CO). This is because the truck will not be in operation constantly in a load condition for a long period of time. During heavy load and high speed conditions the lift truck requires a richer power mixture setting (1.0 to 1.5 percent CO). L R Vacuum Gauge Method 1. Connect the vacuum gauge to the intake manifold.
Start and run the engine until normal operating tem- perature is reached. Power Mixture Adjustment (3) Power mixture knob 2. Run the engine at high idle. Turn power mixture knob to the middle position. 3. Put a load on the engine by operating the hydraulic system. Engine Speed Method 1. Connect the Electrical System Analyzer to read engine rpm. 4. Monitor the vacuum gauge reading. Turn power mixture adjustment knob toward the "L" (lean) posi- tion, until the vacuum starts to drop. The correct mixture is the point at which the vacuum starts to drop. 2. Check to be sure the ignition timing is set correctly. 3. Run the engine until normal operating temperature is reached. 4.
Turn the power mixture knob (3) midway between lean (L) and rich (R). 5. Accelerate the engine to high idle rpm. Put a load on engine by holding the tilt cylinder against relief. 6. Turn the power mixture knob toward lean (L) until engine rpm drops. 7. Turn the power mixture knob toward rich (R) until the rpm recover. 8. The correct mixture will be that setting just before the engine rpm drops. G424 Service Manual LPG Fuel System 78