Assemble LP Gas Carburetor LP Gas Fuelock Remove & Install LP Gas Fuelock 1 16 14 13 15 P0004829 3 1. Check all parts for damage. Replace damaged parts with new as necessary. 2 P0002926 2. Make sure all parts are clean and free of dirt and foreign material. 1. Disconnect fuel lines (1). 3. Put throttle shaft (17) in position in the throttle body, and install stop lever (16). 2. Disconnect wire (2). 4. Put throttle plate (15) in position and install the two screws. 3. Remove fuelock (3). NOTE: For the installation of the LP gas fuelock, reverse the removal steps. Apply loctite PST or equivalent to fuelock pipe threads before installation. 5. Assemble in reverse order of disassembly. NOTE :
Air valve diaphragm must be oriented with position mark pointing toward LPG inlet. 6. See Testing & Adjusting for proper test and adjust procedures. End By: a. Install LP Gas Carburetor. G424 Service Manual LPG Fuel System 84