1. Screw (6) 5. Remove intermediate cover (11), diaphragm (12) and the secondary regulator valve (13). 2. Cover Assembly, Secondary 3. Diaphragm Assembly, Secondary Inspection, Assembly of LP Gas Converter 4. Screw, 1. Clean primary and secondary valves with soap and warm water and inspect for wear. Replace if required. 5. Lever, Secondary 6. Pin, Secondary Fulcrum 7. Seat, Secondary 2. Clean primary and secondary diaphragms with soap and warm water and inspect for wear. Inspect primary diaphragm lever for straightness. Replace if required. 8. Spring 9. Body Assembly With Jet 3. Alwasy replace the coolant chamber gasket. 10. Screw (2) 4.
Clean regulator castings with parts cleaning colvent and inspect. It is very rare for the castings to require replacement. 11. Gasket, Body To Body Cover Plate 12. Pin, Valve Primary 13. Plate, Body Cover 5. Reassemble regulator. 14. Plug 6. Use an anti-seize compound on screws. 15. Spring, Primary 7. Use an approved pipe sealant on fittings. 16. E Ring, External 17. Diaphragm Assembly, Primary NOTE: For assembly of the LP gas converter reverse the disassembly steps. 18. Cover, Primary 19. Screw (7) G424 Service Manual LPG Fuel System 86 10 IDED051P