eng — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE CAUTION WARMING UP OPERATIONS WARNING 3 - 52 BREAKING IN THE NEW M ACHINE NOTICE Before operating the machine for the first time, check that there is coolant in the r adiator. If the machine has b een delivered without coolant in the radiator, run water through the system to flush the system th oroughly, then fill the radiato r with coolant. Your Komatsu machine has been th oroughly adjusted and tested before shipment. H owever, operating the machine under severe conditions at the beginning can ad versely affect the performance and shorten the m achine life. meter).

Be sure to break-in the machine fo r the initial 100 hours (as indicated by the service During break-in operations, follow the precautions described in this manual. Idle the engine for 5 minutes after starting it up. oads or at high speeds. Avoid operation with heavy l Immediately after starting the engine, avoid sudden starts, sudden accele ration, unnecessary sudde n stops, and sudden changes in direction . Emergency stop When a failure or something un usual takes place on the machine, turn the starti ng switch key to the OFF po sition, and the electrical system ceases to func tion and the engine stops. Then ask the Komatsu d istributor in your territory for t he inspection.

If you try to operate the work e quipment without sufficient machine warming-u p, the work equipment may respond to an activated control lever or switc h only slowly, or move against the operator's inte ntion, or an automated opera tion does not function properly. Hence be sur e to warm up the machine prior to starting the wor k. This particularly applies to the cold start, which requires sufficient machi ne warming-up. NOTICE The right hydraulic oil tempera ture level is between 50 to 80°C. Even if it becomes unavoidable to start the work with the mes unavoidable to start the work with the hydraulic oil temperature still a t a low level, do so only after the temperature ris es up to approx.

20°C. That practice helps extend the machine life. Refrain from jerky operation of t he control levers and the work equipment, when the hydraulic oil temperature remains lower than 20°C. ne suddenly until after the engine warming-up is completed. Do not try to accelerate the engi ne suddenly until after the engine warming-up is Do not run the engine either at l ow idling (low revolution) or at high idling (high r evolution) for more than 20 m inutes. Such a practice brings about an advers e effect not only on the environment but also on the internal mechanism of the turbocharger and the engine. ither apply load on the engine every now and then or run the engine at a medium speed.

If the engine idling is required, e ither apply load on the engine every now and the n or run the engine at a medi After starting the engine, do no t immediately start operations. First, perform the following operations