eng — OPERATION OF WORK EQUIPMENT

. OPERATION OPERATION Should any error code other than those listed above be displayed on the screen, consult the Komatsu distributor in your territory. 3 - 65 ERROR CODE DISPLAY DEVICE When some f ailur e or abnormali ty takes place o n the machine, this functi on denotes the cause with a code numbe r consisting of two alphanumeric letters. This c main The L ode numbe control box. X controller r is shown on the LX controller display inside the display describes divers machine conditions in sequence. For details on error codes, see the s the dis ection play sequence and contents of the of "FAILURE DISPLAY BY LX .

CONTROLLER ( PAGE 3-121)" All the conceivab le causes for t he stop of the w ork equipment and respective corrective actions ar e shown in the table below. Error code reference table Contents of Error Error Code Major Cause Co rrective Action Abnormality occurred on primary belt conveyor 00 Abnormal laod is generated on the primary belt conveyor cnnecting line. Remove ex Check that some foreign object is stuck or caught the abnorm in the rollers or frame of the primary conveyor belt. cessive load causing ality. Abnormality occurred on debris dishcarging belt conveyor 02 Abnormal load is applied to debris discharging conveyor connecting line.

check that no foreign Remove ex oject is stuck or caught in the rollers or frame of the the abnorm conveyor. cessive load causing ality. Abnormality occurred on magnetic selector 03 Abnormal load is applied to the magnetic selector connecting line. Check that no foreign object is Remove ex stuck or caught in the rollers or frame of the the abnorm magnetic selector. cessive load causing ality. Abnormality occurred on crusher 05 Abnormal laod is applied to the crusher connecting line. Check that no Remove ex foreign object is stuck or caught in the crusher the abnorm chamber. cessive load causing ality.

Abnormality occurred in engine oil pressure 07 Stop the en Engine lubricating oil pressure lowers the normal engine lubr level. as oil level gine and check the ication system, such in the oil pan, etc. 08 stop the en Battery is being charged abnormally. battery term laternator, Abnormality occurred in engine water temperature 0d Stop the w idle the eng Engine water temperature exceeds 105°C. the engine gauge poin ork temporarily and ine at low speed until water temperature ts to the green zone.