eng — OPENING-CLOSING TYPE HOPPER

. OPERATION OPERATION OPENING-CLOSING TYPE HOPPER PROCEDURES FOR OPERATING OPENING-CLOSING TYPE HOPPER WARNING NAME OF EACH PART AND COMPONENT cylinder (cylinder head 3 - 67 APPLICATION intended to keep the overall machine height less than 3400 mm (11 ft 2 in) and the in-transport l height less than 4000 mm (13 ft 1 in), and effective at reducing labor hours required to overhaul nts and transport them separately.

This practice is and in-transport machine overal n 4000 mm in), and effective at reducing labor hours required to overhaul required to overhaul large compone nts and transpor Keep well clear of the hopper and d o not enter th e operati on radius of t he hopper, while openi ng and closing it. If it becom es necessary to climb on the feeder for installin g a hook, whe n removing the wedge s, be sure t o stop the engin e first, attach a sa fety be lt to the worker an d tthen start t he work.

(1) Wedg e (righ t and left corner (2) Lifting hook (3) Hoppe side) (4) Lifting hook (5) Side h opper (6) In-transport feeder securing Hopper support (fron t) h box Hopper control switc Hopper locking lever (right and lef Hopper support (re ar) opper) Rear hopper Lifting hook (rear h