eng — RUN-IN OPERATION OF JAW CRUSHER

. OPERATION OPERATION LOADER OPERATION FEEDING AMOUNT OF DEBRIS AS RAW MATERIAL Continue with the ordinary operation after the running-in, keeping the debris feeding amount less than 60% of the crusher chamber capacity. STOP OF WORKS After terminating to feed fresh debris, stop the motor, confirming that crushing work has been completed finished.

3 - 76 RUN-IN OPERATION OF JAW CRUSHE After c onfirming by inspec tion that there is nothi ng unusua l with the ja w crusher, carry out both no lo ad operation and lo aded o peration by w ay of running-i n in the following manner, b ut this s hould be co nducted only a t the time of the init NO-LOAD OPERATION FOR MORE THAN 3 HOURS NOTICE Carryo ut a running-in also wh en replacing a cr usher we aring parts or r eversing a jaw p late. I f load i s increase d fast, partial friction may be cause d to various inn er parts, leading to their shortened service life Check if the bearings hav e generated ab normal heat.

Start t o feed fresh debris t o the jaw crush er after confirmin g that the crusher revolution stay s steady a nd constant. If the d ebris are found dir ectly hitting the swing j aw protector, after starting the eeding , try to c hange the eeding mode so tha t they will not hit the protect The fe eding amount at a t ime should not be up t o the full c apacity, but follo w the value s shown i n the table below. Loade d operation (after n o-load operatio Load Ratio (Charging Amount) % No. of Days 30 Two days 60 Two days 60 - (100) After the days above