eng — EFFICIENT USE OF JAW CRUSHER

. OPERATION OPERATION USAGE OF JAW CRUSHER GRAIN DISTRIBUTION, ADJUSTMENT OF CRUSHER OUTLET CLEARANCE AND CRUSHABLE AMOUNT Dimension in grain size distribution = Outlet clearance - 10 mm (0.4 in) direction "b" (crusher width) or debris such as concrete, meanwhile, they may be 3 - 82 DEFINITION OF "UNDER 40" The grain size of 0 to 40 mm (0 t o 1.6 in) shown in the catalog indicates a grain size distribution in which the istribution maximum size of the crushed conc rete block is 50 mm (2.0 in) in diameter and and concret e blocks smaller t han 40 mm (1.6 in) account for approx. 95 % of all. ADJUSTMENT OF CRUSHER OUTL ET CLEARANCE The clearance value is the maximu m width of the outlet.

If this is adjusted to 55 mm (2.2 in), t he grain size of c rushed debris is less than 40 mm (1.6 in) o n condition that debris to be crushed is a concrete block; both fixed jaw pl ate and swing jaw plate are brand new; the grizzly bar pitch is 50 mm (2.0 in). s; Generally dimension in the grain si ze distribution can be defined as follow GRAIN DISTRIBUTION The jaw crusher outlet is so shaped The clearance can be adjusted in d stroke), but cannot be adjusted in vertically. Accordingly the grain size of crus which can be crushed to a cubic fo to 1.6 in) in diameter with OSS set of all. When natural rocks are crus crushed flatly along their grains.

As range of 0 to 40 mm (0 to 1.6 in) is NOTICE When crushed debris are heaped up, bl ocks of larger grain size are outstanding. Thi s is because the la rger a grain size is, the less specific gravity a block has and blocks of large grain size tend to surface. Usually there are more gra ins of small diame ter than it appears. When crushing natural stones, the mini mum allowable outlet clearance is 100 mm ( 3.9 in). If set at less than 100 mm (3.9 in ), it can cause a damage on the crusher main b ody and premature wear of the jaw plates. CRUSHABLE AMOUNT The crushable amount shown in the catalog is a value measured under the condition of the b est adjustment.

I n order to gain the practical value in the or dinary crushing work, therefore, it is rec ommended to m ultiply the catalo g value by work coefficient of 0.6 to 0.75.