eng — STARTING MACHINE AFTER LONG-TERM STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING When using the machine after long-term storage, do as follows before using it. Wipe off the grease from the hydraulic cylinder rods. Be sure to apply oil and grease to all the parts requiring lubrication. 3 - 110 BEFORE STORAGE orage for a long time, do as follows. When putting the machine in st Clean and wash all parts, the n store the machine indoors. If the machine has to be stored outdoors, sel ect level ground and cover the machin e with a sheet. before storage. Lubricate and change the oil Disconnect the negative term inal of the battery and cover it, or remove from th e machine and store it sep arately.

If the ambient temperature is expected to drop below -0°C, always add antif reeze to the cooling wate r. Since Komatsu genuine Super Coo other antifreeze as long as th If the temperature may drop INSIDE OF COOLING SYST lant (AF-ACL) is added to the coolant water norm ally, it is not necessary to add any e temperature is not expected to drop be -10°C. Grease the exposed surface ylinde primary belt conveyor, option al hopper opening and closing cylinder and option al side conveyor storing c ylinder). Set the travel safety lock to t he LOCK position.

If it is necessary to perform the rust -prevention operation while the machine is indoors, op en the doors and windows to improve ventilation and prevent gas poisoni ng. Operate the engine and move th e machine for a short distance once a month so t hat a new film of oil will b e coated over movable parts and compo nent surfaces. At the same time, also charge the AFTER STORAGE NOTICE If the machine has been stored wit hout carrying out the monthly rust-prevention operati on, consult your Komatsu d istributor before using it. STARTING MACHINE AFTER LONG-TERM STORAGE When starting the engine for the first time after a long storage period, observe the following procedures 1.

Turn the starting switch key 2. Turn the fuel control dial fro position for three seconds. 1. Turn the starting switch key 2. Turn the fuel control dial fro m the low idling (MIN) position to the full speed ( MAX) position, and hold o n at that Then return the dial to the low idling position and start the engine.