. OPERATION TROUBLESHOOTING 3 - 116 ELECTRICAL SYSTEM ( ) : Always contact your Komatsu distributor when dealing with these items. In cases of problem or causes which are not listed below, contact your Komatsu distributor for repairs. Abnormal Phenomenon Major Cause Corrective Action The lamps are dimly lit even with the maximum engine speed. Wiring fault Improper belt tension adjustment Check and correct loosened terminals and disconnection. Adjust belt tension. The lamps flickers while the engine is running. The charging level monitor flickers while the engine is running. ( Replace) ( Check and repair) Abnormal noise is generated in the alternator.
Alternator fault ( Replace) The starting motor does not rotate with the engine starting switch turned on. Charge battery ( Check and repair j ( Replace) ( Replace) The starting motor alternates engagement and disengagement. Charge battery. ( Replace) The starting motor turns the engine slowly. Charge battery ( Replace) The starting motor is disengaged before the engine is started. ( Check and repair) Charge battery Preheater monitor does not lights up.
Wiring fault Heater relay fault Monitor fault Glow plug disconnection ( ( ( ( Check and repair) Replace) Replace) Replace) Engine hydraulic oil pressure monitor remains lit up for more than three seconds, even after the engine is stopped (with the starting switch ON). Monitor fault ( Replace) Engine hydraulic oil monitor flashes while the engine is running. ( Replace) ( Check and repair)