. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 30 4. Hook the top of the ladder to the piping prov at the left side of the machine. 5. Open the doo machine. r located on the left side at the rear of the ction cover (5) on the radiator undercover, and t of a draining extension hose in the coolant and iving container. ve (3) to drain the coolant. ve (3) after drainage, and fill the radiator with tap iator is completely filled, start the engine and at low idling. ve (3) and clean the radiator with running water , keeping the engine at low idling.
the radiator with running water, try to adjust input and output so that the radiator is kept full p a close watch on the water supply hose during hould come off the radiator water cap. e after the cleaning work. water and close drain valve (3). , clean the interior with detergent. detergent, follow the instructions for detergent 6. Remove inspe place the outle t of a draining extension hos antifreeze rece iving container. ve (3) to drain the coolant. 7. Open drain val 8. Close drain val ve (3) after drainage, and fill water. When the rad keep it running 9. Open drain val ve (3) and clean the radiato 10.
for ten minutes , keeping the engine at low While cleaning the radiator with running cleaning water input and output so that the at all time. Kee p a close watch on the water supply lest it s Stop the engin hould come off the radiator e after the cleaning work. Stop supplying water and close drain valv 11. After drainage , clean the interior with dete For the use of detergent, follow the instruc to be used. 12. After drainage , open drain valve (3) to drai n all the water, then close it and fill the radia tor with tap water almost up to the radia tor cap. 13.
When water is filled up to the radiator cap, open drain valve (3) and continue to clean the radiator with running water until clea n water comes out, keepin g the engine at low idling. While cleaning the engine with running wat er, try to balance water supply and drainag e to keep the radiator full of cleaning wa ter at all time. the engine and close the drain valve. en valve (1). sistor, see the section of "REPLACE CORROSION RESISTOR 14. When clean w ater begins to flow out, stop 15. Replace the co rrosion resistor and then op For the replac ement of the corrosion re PAGE 4-77)". CARTRIDGE (