eng — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE plate and place it on the crusher rea frame rope again to let it through between the round 4 - 52 14. Take out the tog [Toggle plate w 15. Fix an eyebolt o n tap (B) of a new toggle p late and wind a wire rope around it. 16. provisionally. Hook the wire r 17. pipe and swing 18. Lower the toggl e plate slowly and match it to the center o f the seat on the togg le block side. . n mode selector switch to the INSPECTION 19. 20. Start the engine Set the operatio 21. position. Attach a warnin g tag to the engine starting switch to announce to those concer ned that the machine is no w worked on. n the 22.

Depress the cru sher outlet clearance red uction switch i upper control bo x, try to adjust the wire rop e lifting length, while pushing the to ggle block forward, and then determi ne a position where t he front contact surface of the toggle plate and the contact surf ace of the swing jaw seat contact are aligned. 23. When the positi on has been determined, p ush the toggle block forward a bit furt her, and pull out the swing j aw stopper fro m the stopper seat. . e rope and eyebolt fitted to the toggle plate. 24. Stop the engine 25. Remove the wir e rope and eyebolt fitted to the toggle pla