eng — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE REPLACEMENT OF TOGGLE SEAT WARNING CAUTION referring to of the (bolt in use: M16 x 4 bolts) on both sides of the [Weight of toggle seat on swing jaw side: 38.6 kg (85 lb)] 4 - 54 Before replacing the tog gle seat, never fail to observe the follo Check that the swing jaw stopper is surely inserted into the stopper sea After a long and conti nuous use of the machine , the toggle seat may hav e been defor med and firmly stuck to the toggle block o r swing jaw.

In such case, weld a hook to the toggle seat a t the center, and pull out the worn toggle sea Depending on the sit uation, gas-cut the worn t (material of toggle se The toggle seat has no p arts interchangeability. H ence take ca re to install i Toggle seat on swing ja w side: Protruding amoun t 25 mm (1.0 in) and protruding down Toggle seat on toggle bl ock side: Protruding amount 50 mm ( 2.0 in) and protruding dow 1. Start with removi ng the toggle plate beforehand, r the section dealin g with replacement of t he toggle p manual. Remove toggle s swing jaw. 2. 3. Screw an eyebolt (M12) into tap holes toggle seat and h ook a wire rope to i Tool to use Eyebolt: Accesso 4. Lift up the toggle