eng — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CAPTRIDGE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING filter 4 - 67 Do not try to change oil, once the engine is started, since various pa rts of the engine have already be en warmed up to a high temperature. Replace the engine o Container with capacity ove r 34 liters (8.98 US gal) to recei Replacement oil amountof o Filter wrench 1. Take out maintenance ladd er (1) stored under the primary conveyor. 2. Hook the ladder to a pipe lo cated under a door on the right s at the rear of the machine. ide at the rear of the machine. 3. Open the door on the left s 4.

Remove the inspection lid on the undercover located dir under an extension hose f or draining the engine oil, and pl a container beneath. 5. Drain the engine oil by raisi ng the drain valve lever slowly. A all the oil has been draine valve. d, lower the level to close the dr 6. Open the engine hood, and in order to remove the fi cartridge, turn it to the left with a filter wrench from above engine. A lot of oil will flow out just after the engine stops, before starting the job. l a new filter cartridge with cl wait for about ten minutes 7. Clean the filter stand. Fil engine oil.

Coat clean engi ne oil on the packing and thread the new filter cartridge (a t hin layer of grease will do, too), then install the filter cartrid ge. REMARK Check that there is no old packi ng affixed to the filter holder. If th is any old packing affixed to th e filter, it will cause leakage of o