eng — REPLACE HYDRAULIC FILTER ELEMENT

. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC FILTER ELEMENT WARNING and may cause burns. Wait for the 4 - 71 temperature to go do wn before starting t he work. When removing the oil filler cap, turn it s lowly to r elease the interna l pressure, t hen r the engine 1. Remove the cap pressure. from oil filler (F), and release the internal hen remove cover (1). 2. Loosen 4 bolts, t hen remove cover When doing this, the cover may fly out under the force of spring (2), so hold the c over down when r emoving the bolts. 3. After removing s pring (2) and valve (3), tak e out element ( 4. Clean the remov ed parts in diesel oil. 5.

Install the new el ement in the place where o ld elemen t (4) w as installed. spring (2) on top of the element. 6. Set valve (3) and spring (2) on top of the el 7. Set cover (1) in p osition, push it down by ha nd, and i nstall the cover with the m ouning bolts. ller cap and install the cover. start the engine according to "STARTING 8. Screw in the oil fi ller cap and instal l the cov 9. To bleed the air, start the engine accordi ENGINE (PAGE 3-49)" and run the engine at low idling for 10 minutes. 10. Stop the engine. REMARK Wai t for at least 5 mi nutes after stopping the ei gine to eliminat e bubbles in the oil inside t he tank. 11. Check for oil leak age and wipe off any spill