eng — CHECK AND INSPECTION

. ATTACHMENTS, OPTIONS HYDRAULIC TYPE MAGNETIC SELECTOR belt conveyor. Pay clearance of 30 to 40 mm (1.2 to 1.6 in) from the lower surface of the magnet on the main body. 3) In case debris are stuck at the backside of the belt; Remove them as soon as found, since they can cause a damage on the belt or the pulley. 4) In case the belt or any other relative parts is damaged; Replace it with new one promptly.

6 - 4 CHECK AND INSPECTION The discharging belt for this m tha attention to the following points, when starting the day's work or daily i Has the belt been biased or d Is the belt tension appropriate Are debris stuck to the backsi Has the belt surface been scr Has the belt scraper not been Have metal parts or or bolts a t the connetion of the belt end not bee n damaged or fallen off If anything unusual is found, tak e the following actions. ed or makes a snaky movement; take-up unit, referring to the figure consists of a base plate, a pillow en the lock bolt on the base plate of the take-up unit with the tap tighten the lock bolt again.

When than 10 mm (0.4 in) at both ends the flange at the end of the pulley, sition. s not appropriate; in the same way as mentioned ust the belt so that it will have a