eng — ON USE OF RADIO CONTROL UNIT

. ATTACHMENTS, OPTIONS RADIO CONTROL UNIT SAFETY CHECK WARNING To check if the radio control unit is properly functioning, follow the procedures explained below. 1) Set the engine starting switch in the main control box to the ON position. 2) Turn the radio control unit ON/OFF switch in the main control box to the ON side. 3) Set the POWER switch in the transmitter to the ON position. 4) Pull the TRANSMISSION STOP switch in the transmitter. The revolving working lamp on the machine comes on. The radio control unit may be operated now.

REPLACEMENT OF BATTERY WARNING or bring it under safe conditions (0) position and switch off the 6 - 25 Before starting the work, check that t here is nobody or no obstacle in the surrounding and sou nd a horn for caution. Particularly when using the radio con trol unit, pay special attention to the machine and the surro unding, and start usin g the radio control unit only after judging that th ere is no safety problem around at all. Check list when starting work this check list) ge on the safety devices of the transmitter. (Conduct a cloth check based on 1. Check that there is no dama Check the switches and the o part is properly repaired. 2. Check that the POWER swit 3.

Install the charged batteries i 4. Turn the POWER switch key 5. The transmitter's red lamp be 6. The transmitter's green lamp working lamp (blue) comes o With this, the unit is ready for 1. Check that there is no dama ther vital parts for any damage. If any, do not start the work until after that damaged ch of the unit is set at the OFF position. n the battery holder at the bottom of the transmitter. of the unit to switch on the transmitter. gins to flash. begins to flash about two seconds after that and at the same time the revolving n. operation. 2. Check that the POWER swit 3. Install the charged batteries i n the battery holder at the bottom of the transmitter. 4.

Turn the POWER switch key 5. The transmitter's red lamp be 6. The transmitter's green lamp NOTICE As long as the TRANSMISSION STOP switch remains depressed, the work equipment cannot b Release the switch by depressing it a gain and start the work equipment. When the charged level in the batterie flash. In that case, take the following Move the machine to a safe plac within 30 seconds, using the radio The transmitter is put in the STOP Turn the POWER switch to th transmitter. Pull out batteries (1) from the batte Insert charged replacement batter The radio control unit is now read