jac Manual (EN)

All information in this Owner's Manual is current at the time of publication. However JAC reserves the right to make changes at any time so that our police of continual product improvement may be car 鄄 ried out. This manual applies to all current JAC models and includes description and explanation of option as well as standard equipment .As a result 袁 you may find material in this manual that does not apply to your specific vehicle.

Стр. 1

Preface Thank you for choosing JAC. We are pleased to welcome you to the growing number of discriminating people who drive JAC. The advanced engineering and high -quality construction of each JAC we Note: Because future owners will also need the information included in this manual, when you sell this build is something of which we are proud. vehicle, please leave it in the vehicle for their use. Thank you. This Owner's Manual will introduce you to the features and operation of your new vehicle. If is sug 鄄 gested that you read it carefully since the information it contains can contribute greatly to the satisfac 鄄 tion you receive from your new vehicle.

The manual has been edited on the basis of the truck air over hydraulic brake, left-hand drive vehi 鄄 The manufacturer also recommends that all service and maintenance on your vehicle be performed cle. On the other models, only the differences have been covered. Some illustrations may not coincide by an authorized JAC dealer. JAC dealers are prepared to provide high-quality service, maintenance with your vehicle, but the contents of explanations are common. The material in this publication may and any other assistance that may be required. not be reproduced in any form without written permission from the JAC Motor Company. ANHUI JIANGHUAI AUTOMOBILE CO. 袁 LTD. JUN. 2008

Стр. 2

SAFETY AND VEHICLE DAMAGE WARNING Contents Page This manual includes information titled as WARNING, CAUTION and NOTE. These titles indicate the following: BEFORE DRIVING 1 WARNING: This indicates that a condition may result in harm or injury to you or other persons if the warning is not heeded. Follow the advice provided with the warning. INSTRUMENTS & CONTROLS 16 STARTING & OPERATING 74 IN CASE OF EMERGENCY 113 CAUTION: This indicates that a condition may result in damage to your vehicle or its equipment if the caution is not heeded. Follow the advice provided with the caution. APPEARANCE CARE 131 VEHICLE MAINTENANCE REQUIREMENTS 137 TRACTOR 183 NOTE:

This indicates that interesting or helpful information is being provided. MIXER 187 VEHICLE SPECIFICATION 210

Стр. 3

OWNER 爷 S MANUAL JAC HEAVY DUTY TRUCK 1. IMPORTANT INFORMATION 2. BEFORE DRIVING YOUR JAC The followings are very important for the correct management and economic use of JAC vehicles, and they shall be read BREAKING IN YOUR VEHICLE carefully before use and maintenance. Operate the vehicle at moderate speeds during the first 1,000 km (600 miles) to break it in. Make certain that the follow 鄄 Nameplate The nameplate is located near the VIN, on which it marked with information ing points in particular are strictly observed. 荫 Allow the engine to warm up fully until the coolant temperature reaches about 60 益 (140 ).

about the vehicle, such as its vehicle model, engine model, ex-works date, 荫 Avoid racing the engine, abrupt start, acceleration and braking. etc. 荫 Avoid overloading the vehicle, as this will result in a shorter life. Chassis number 荫 Avoid high speed operation as far as possible. During break-in operation, make sure that the engine speed does not exceed 1,500 rpm. The chassis number, that is VIN code number, is stamped on the outer side of Make sure that your vehicle does not miss the first 1,000 km(600 miles) and 5,000 km (2,500 miles ) inspections. the right longeron end of the frame.

After the first 1,000 km (600 miles) and 5,000 km(2,500 miles) or driving, take your vehicle to your nearest service shop for inspections based on the 'Maintenance Requirements'. Overload NOTE: Must have the engine of your vehicle checked at the authorized JAC service station. If you do not follow the pre 鄄 Overloading will shorten vehicle's service life, but also bring about potential caution it may cause a series damage to the engine and is not covered by JAC. risk to safe driving. The loading mass must be limited to the specified range of the max.

total mass for vehicle, and the load distributions on the front and rear shafts shall not be more than the carrying capacity of the vehicle shafts. Please refer to the techni 鄄 cal specification sheet for the rated total mass value and shaft loading capacity. 2 3

Стр. 5