Western Star Bodybuilder Book: Revision 3.2a 1A In Cab Body Builder Connections P. 1A-29 b In Cab Body Builder PDM T.o.C. Note: The fuse panel option is not required in cases Ÿ Dedicated raceway to route wiring for body install where Body Upfitters are installing their own PDM Ÿ Floor Tray accommodates (6) 1/2” bundles systems. If you are in doubt call ahead and check Ÿ Raceway system provides access cover to route wires before ordering.
Ÿ Cab access through access floor plate 4” pass-thru in cab floor If a PDM system will be installed order the Ÿ In-cab body builder fuse and relay system isolates body controls from truck system for a simple and more reliable truck and Body integration operation Body Builder PDM is Mandatory with the following high amperage switch options the PDM unit can be omitted in certain cases with these combinations where the body builder is supplying their own PDM (engineering review required) 329-068 - (4) 20 amp switches wired behind passenger seat 353-060 - Body lighting interface blunt cut wiring with fuse panel 329-072 - (6) 20 amp switches wired behind passenger seat wire mounted between driver and passenger seats 329-076 - (10) 20 amp switches wired behind passenger seat 353-061 - Body lighting interface blunt cut wiring with fuse panel wire mounted between driver and passenger seats with additional 150 amp service 353-062 - 150 amp service for body builder installed components driver and passenger seats AUXILIARY PNDB Module 33P Body Lighting PDM Module 353 Cab Floor Harness Module 287 Mounting Bracket Module 33M Power Distribution Module 33M Blunt cut switch connections Pre wired to dash switches and Cab Aux lighting PDM see schematic Power Cable Section 1 Page (1-31) Module 33M Module 329 Models:
4700L Models: 4700L