STEERING COLUMN-MOUNTED CONTROLS the washing cycle. After the lever is released, the wipers will shut off automatically or resume the wiper’s setting speed. The ignition key must be turned to ON or ACC for the wiper/washer switches to operate. NOTE Do not use antifreeze or engine coolant in the windshield washer reservoir - damage to seals and other components will result. CAUTION To activate the wipers for one swipe without activating the washer ("mist" function), push the turn signal lever in (towards the steering column) and release in less than 0.5 seconds. The wipers will perform a single swipe and then resume the wiper’s setting speed.
CAUTION If the electric pump is operated for a long period (more than 15 seconds) with a dry reservoir, the pump motor may be damaged. 3 Wiper/Washer WARNING! The first position after OFF is the intermittent #1 cycle. The next positions are intermittent #2, #3, and #4. The last two positions are wiper low speed and wiper high speed. Clean blades regularly with a damp cloth to remove road film and wax build-up. Do not drive with worn or dirty wiper blades. They can reduce visibility, making driving hazardous which may lead to an injury accident resulting in death or personal injury. Check the windshield washing fluid level daily. If necessary, fill to top.
Clean all inside and outside windows regularly. Use an alcohol-based cleaning solution and wipe dry with either a lint-free or a chamois cloth. Avoid running the wiper blades over a dry windshield to prevent scratching the glass. Spray on washer fluid first. A scratched windshield will reduce visibility. To wash the windshield Push the rotary wash/wipe knob in (towards steering column), hold for more than 0.8 seconds and then release. Hold the knob in to extend (03/17) Y53-6060-1C1 3-45