Peterbilt Medium Duty — Regeneration Switch

DASH- AND DOOR-MOUNTED CONTROLS Regeneration Switch to release the button to ensure that the system will begin the regeneration cycle. This vehilcle’s electronic system will perform a ‘rationality check’ every time the vehicle is started. This check is to ensure that the service brakes are working before allowing cruise control to function. This safety feature is designed to ensure that a driver is able to cancel the cruise set speed by using the service brake pedal. The system will not allow cruise control operation if it does not pass the ‘rationality check’.

The Driver Information Display will prompt you to press the service brake pedal if it has not been pressed since the vehicle has been started. In order to meet 2007 EPA engine emission requirements, vehicles will have a either a two or three position switch to help control and maintain the exhaust Diesel Particulate Filter. Please refer to the Exhaust Aftertreatment System Supplement provided with the vehicle for more detailed information about the emission control system. CENTER: (three position switch only) Center is the normal position of the switch. The center position will allow an automatic regeneration to occur. 3 STOP:

(three position switch only) When STOP is pressed the system will not regenerate under any conditions. CAUTION Do not leave the three position switch in the STOP position unless you need to cancel or stop regen- eration. Leaving the switch in the STOP position for extended periods of time will result in increased soot levels in the DPF. START: Depressing the button in the START direction for 4 to 8 seconds will initiate a parked regeneration. Be sure 3-52 Y53-6060-1C1 (03/17)