OPERATING THE TRANSMISSION Transmission Warm–Up Putting the Vehicle in Motion cause a very jumpy start and excessive wear. In cold weather [below 32°F (0°C)], you may find shifting sluggish when you first start up. Transmission warm-up is especially important at this time, but it is always a good idea to warm your transmission oil before starting out on the road. After making sure the vehicle's oil and air pressure are correct and all other parts and systems are in proper working condition: CAUTION Always use first gear or a low speed range to start the vehicle in motion.
The use of a higher gear or speed range forces undue strain on the en- gine, clutch, other transmission com- ponents, and may cause damage. 1. If your truck is equipped with a hand throttle, disengage the hand throttle before driving the vehicle. To warm the transmission lubricating oil during engine warm-up: 2. Fully depress the clutch pedal until the clutch brake makes contact. The contact will occur at about 1 inch or less from the floorboard. 3. Evaluate the road surface conditions and terrain your vehicle is on. Select a gear low enough to let your vehicle start forward with the throttle at idle. 1. Put the transmission in Neutral. 4 2.
Release the clutch pedal and let the transmission operate in Neutral for three to five minutes prior to shifting into either a forward or reverse range. ° The total stroke of the clutch pedal is about 10 inches. The first 1Ѕ inches is free travel. After the free travel comes the release stroke, which is the part that fully releases the clutch. The last inch engages the clutch brake. 4. Push the parking brake valve handle (Yellow) against the dash panel to release the brakes. 5. Release the clutch pedal, then gradually accelerate to permit smooth starting, ° Always start out in a low gear. Starting in a higher gear, even with a light load, will 6.
Do not allow your vehicle to roll (even a little) in the (03/17) Y53-6060-1C1 4-15