Peterbilt Medium Duty — Introduction

OPERATING THE BRAKE SYSTEM Special Trailer ABS (Without PLC) Option For doubles or triples, the lamp does not distinguish between trailers. An ABS problem in any of the trailers will activate the Trailer ABS Warning Lamp. NOTE The center pin of the 7-way trailer light line may be constantly powered for ABS. Make sure it will not acci- dently turn on trailer equipment.

CAUTION If a trailer does not have PLC, but it does have ABS that is powered through an optional second trailer connector (ISO 3731) and that trailer ABS is designed to control the Trailer ABS Warning Lamp in the cab and the vehicle has been ordered with the option to turn on this lamp for these types of trailers, then this lamp will turn on when that trailer ABS has a system problem. This should be checked by a dealer as soon as possible. The Trailer ABS Warning Lamp will not turn on for the power-on test when connected to these types of trailers. NOTE If you change the intended service in any way (i.e.

number of axles, mul- tiple trailers, add switchable trailer accessories, etc.) from the date the vehicle was manufactured, you should contact your trailer manufac- turer and/or trailer anti-lock brake manufacturer to determine if the power available at the 7-way trailer light line is adequate. Failure to do so might result in insufficient power to the trailer ABS system which may affect its operation. 4 NOTE Very few trailers built before 3/1/01 have this option. Trailers built after 3/1/01 are built with PLC technology. (03/17) Y53-6060-1C1 4-27