OPERATING THE BRAKE SYSTEM Parking Brake Burnishing 40 pounds) until the vehicle is brought to a stop. Do not allow the wheels to lock up. No indication will be given via the dashboard warning lights or buzzer if tires of the wrong size are installed on your vehicle. The Anti-Lock Brake System (ABS) is calibrated for the specific tire revolutions per mile. Use of a tire and/or wheel size different from that originally installed on your vehicle may cause the ABS system to not function during a hard braking event. This could cause an accident or serious personal injury.
Consult with your Peterbilt dealer before using a different tire and/or wheel size than was originally in- stalled on your vehicle. WARNING! This procedure is recommended for new vehicles where less lever actuation force is required. This procedure is mandatory whenever the driveline brake shoes or brake drum are replaced. 3. After stopping, release the parking brake lever and drive the vehicle at 20 mph (32 km/h) in a low gear for approximately 2.5 miles, to allow the brake drum to cool. WARNING! 4. Repeat steps 1, 2, and 3 above until a total of 10 stops have been completed. If a new drum or new brake shoes are installed, the driveline brake must be burnished.
Failure to prop- erly burnish the parking brake before putting it in service could result in an inoperative parking brake, pos- sible vehicle rollaway, and serious personal injury or damage to the vehicle. 4 5. Adjust the parking brake lever. See the Medium Duty Maintenance Manual. 1. Drive the vehicle at 15 mph (24 km/h) in a low gear (first or second) on a dry, hard road surface. 2. Apply the parking brake lever with a moderate force (approximately 4-40 Y53-6060-1C1 (03/17)