Peterbilt Medium Duty — Refueling

STOPPING THE ENGINE STOPPING THE ENGINE Turbochargers Refueling Before Stopping the Engine This cooling-down practice is especially important on a turbocharged engine. The turbocharger contains bearings and seals that are subjected to hot exhaust gases. While the engine is operating, heat is carried away by circulating oil. If you stop the engine suddenly, the temperature of the turbocharger could rise as much as 100°F (55°C) above the temperature reached during operation. A sudden rise in temperature like this could cause the bearings to seize or the oil seals to loosen. Air inside the fuel tanks allows water to condense in the tank.

To prevent this condensation while the vehicle is parked for extended periods of time, fill the tanks to 95 percent of capacity. Never fill to more than 95 percent capacity as this provides room for expansion resulting from temperature extremes. When refueling, add approximately the same amount to each fuel tank on vehicles with more than one tank. A hot engine stores a great amount of heat. It doesn’t cool down immediately after you shut it off. Always cool your engine down before shutting it off. You will greatly increase its service life. Idle the engine at 1000 RPM for five minutes. Then low idle for thirty seconds before shutdown.

This will allow circulating coolant and lubricating oil to carry away heat from the cylinder head, valves, pistons, cylinder liners, turbocharger, and bearings. This way you can prevent serious engine damage that may result from uneven cooling. 4 Do not carry additional fuel contain- ers in your vehicle. Fuel containers, either full or empty, may leak, ex- plode, and cause or feed a fire. Do not carry extra fuel containers, even empty ones are dangerous. Failure to comply may result in death, per- sonal injury, equipment or property damage. WARNING! (03/17) Y53-6060-1C1 4-67