Peterbilt Medium Duty — Safety Restraint System - Inspection

CAB the sun's ultraviolet rays. Replace the system. 4 Buckle casting broken. 5 Retractor Web Storage for damage. (located behind trim panel) 6 Tethers for web wear and proper tightness of mounting hardware. 7 Mounting hardware for corrosion, proper tightness of bolts and nuts. 8 Web for deterioration, due to exposure to the sun Once the need for replacement of the seat belt has been determined, be certain it is only replaced with an authorized PACCAR Parts replacement seat belt. If the inspection indicates that any part of the seat belt system requires replacement, the entire system must be replaced. An installation guide is attached to every replacement belt.

Utilize the proper guide for your type of seat, and follow the instructions very closely. It is vitally important that all components be reinstalled in the same position as the original components that were removed and that the fasteners be torqued to specification. This will maintain the design integrity of the mounting points for the seat belt assembly. Contact your dealer if you have any questions concerning seat belt replacement. WARNING! Failure to adjust tether belts properly can cause excessive movement of the seat in an accident. Tether belts should be adjusted so that they are taut when the seat is in its most up- ward and forward position.

Failure to comply may result in death or per- sonal injury. 5 Seat Belt Inspection Points 1 Web cut or frayed or extremely worn at latch area. 2 Web cut or frayed at D-loop web guide. 3 Comfort Clip cracked or damaged. 5-78 Y53-6060-1C1 (03/17)