ENGINE Pipe and Hose Clamp Torque Values Accessory Drive Belts replace them as soon as you detect trouble. shows an example of the rotation direction to release the tensioner. 5 You can extend the reliability and service life of your vehicle's drive belts with proper attention to installation, and maintenance. Neglect could cause belt failure. The result could be the loss of the electrical or air system as well as possible engine damage from overheating. So it's a very good idea to check your belts frequently and Follow this procedure to install an accessory drive belt: 2. Slip the belt around the idler pulley attached to the automatic tensioner. 1.
Route the new belt around the pulleys, and then rotate the automatic tensioner so that the idler pulley swings toward the belt routing. The following figure 3. Release the automatic tensioner. 4. Check the belt alignment on each pulley. The belt must fall between the flanges of each pulley.
5-102 Y53-6060-1C1 (03/17) APPLICATION APPROVED CLAMP TORQUE Nm Lb-In Radiator & Heat Exchanger Hoses Constant-Torque CT-L 10.2-12.5 90-110 Heater Hoses Constant Tension not required not required Air Intake Pipes Hi-Torque HTM-L 11.3-14.2 100-125 Charge Air Intake Hoses Flex Seal 667 7.9-11.3 70-100 B9296 6-7 50-60 Fuel, Oil & Water Heat Exchangers (for hoses less than 9/16 diameter) Miniature 3600L 1.1-1.7 10-15 Exhaust Clamps Breeze V-Band 54 480