ENGINE Fan Drive and Blade Air Intake System WARNING! Engine heat, vibration, and age combine to loosen air intake connections and cause cracks in the tubing and elbows. Leaks in the intake system allow abrasive dust to enter the engine and quickly cause expensive damage. During your daily walk-around inspection, carefully check all tubing, elbows, clamps, supports and fasteners for condition and tightness. Do not use air intake pipes and con- nections as a step or to pull your- self up. This could loosen the con- nections and open the system to un- filtered air which could damage the engine. CAUTION Do not work on the fan with the en- gine running.
The engine fan can engage at any time without warning. Before turning on the ignition be sure that no one is near the fan. Failure to comply may result in death or per- sonal injury. Fan Blade Clearance: Around the fan shroud, the recommended distance is 1 in. (25 mm) from front edge of any fan blade-to-radiator side member. Minimum clearance is 3/4 in. (19 mm). Check the Charge-Air-Cooler for air leaks annually. The air leaks can be caused by cracked tubes or header. For service see your authorized dealer. 5 Rear edge of any blade must be no closer than 3/8 in. (9 mm) to the nearest engine component. If this cannot be obtained, the fan spacer or fan is not correct.
The leading edge of any fan blade must be 1 in. (25 mm) from the inside edge of the shroud. 5-104 Y53-6060-1C1 (03/17)