JUMP STARTING VEHICLES 7. If either vehicle is equipped with battery disconnects ensure they are in the "OFF" position prior to connecting the two vehicles. Connect the batteries: 6. Start the vehicle that has the good battery first. Let it run for 5 minutes. 1. Attach one end of a jumper cable to the positive (+) terminal of the discharged (dead) battery. This will have a large red + or P on the battery case, post, or clamp. 7. Start the vehicle that has the discharged (dead) battery. 2 2. Attach the other end of the same cable to the positive (+) terminal of the good (booster) battery.
If the engine fails to start, do not continue to crank the starter but contact the nearest authorized dealer. 3. Attach the remaining jumper cable FIRST to the negative (-) terminal (black or N) of the good battery. 4. Attach the other end of the negative cable to a bare metal part not bolted to the engine block. NOTE Always connect positive (+) to positive (+) and negative (-) to negative (-). 5. If either vehicle is equipped with battery disconnects, ensure that they are in the "ON" position. 2-10 Y53-6060-1C1 (03/17)